Home/Product/Anodized Aluminum/Specification
Product Parameters
Substrate Gauge(mm) Width(mm) Length(mm) Anodic layer(μm)
AA5005A 0.3-3.0
(3.5~10mm can be customized)
1700
(Special width can be customized)
Coil 1~25
(Special anodic layer thickness can be customized)
Chemical Composition % (AA5005A)
Si Fe Cu Mn Mg Cr Zn Ti Other Al
0.3 0.45 0.05 0.15 0.7-1.1 0.1 0.2 0.05 0.05 Other
Mechanical Properties
Temper Tensile strength Yield strength Elongation at break HB (only for reference)
  Rm [MPa] Rp0.2 [MPa] Standard guage [mm] A50mm [%] min. min. max.
0.21-0.50 0.51-1.50 1.51-3.00
H14 ≥ 145 ≥ 120 2 2 3 42 54
H18 ≥ 185 ≥ 165 1 2 2 52 65
H24 ≥ 145 ≥ 110 3 4 5 42 54
According to EN 485-2
Physical Properties
Density [g/cm³] Modulus of
elasticity [MPa]
Shear modulus [MPa] Thermal linear expansion
20-100°C [10-6 / K]

Thermal conductivity
[W / (m*k)]
Electrical
conductivity [MS / m]
2.69 69500 26100 23.6 160-220 23-31
Surface parameters
Property Surface Position to rolling dir. Measurement method Typical values

Roughness
631E transverse ISO 4287 / 4288
profile method
Ra 0.3 - 0.6 μm
transverse Rz 2.4 - 3.8 μm
615E transverse Ra 0.2 - 0.3 μm
transverse Rz 1.2 -2.2 μm
Remark:the smaller the value,the finer the surface,the better the surface characteristics.

Copyright © 2018 rehongda.com
Shenzhen Rehongda Building Technology Co., Ltd 粤ICP备18007647号